Correct. The outer 2 pin.1 and 3 on the potHi. It’s late here and I can’t think…
My joystick is currently inverted… the axes are correct, but left is right, push is pull etc…
Which pins do I need to swap? +5v & Gnd for each channel??
Correct. The outer 2 pin.1 and 3 on the potHi. It’s late here and I can’t think…
My joystick is currently inverted… the axes are correct, but left is right, push is pull etc…
Which pins do I need to swap? +5v & Gnd for each channel??
also, they have a US site:Found the Datasheet for Monkey Ball
Monkey Ball
RA25Y 20FB5K
https://www.tocos-j.co.jp/tocos-j-wp/wp-content/uploads/2019/06/RA25_Series.pdf
RA = Wire Wound
25 = 25mm diameter
Y = Temp range between -10 and 100 Deg C
blank = Panel Mount Type
20 = 20mm shaft length
F = Flat shaft
B = Linear
5K = 5K Ohms
Anyone know what brand the [M] logo is for on the other one?
hey all, has anyone been able to source replacement POTs for the the gundam stick? I broke one of the posts off a pot on my gundam stick and I need to replace it
got to love it. they sent me the wrong part. a 270 degree pot instead of the 60 degree I needed.I got mine directly from bandai namco.
Item: VG75-03824-00 - POT,1K 60 DEG,(PKG OF 1)
Qty:1 - EA
EA Price: $41.00 USD
Item Total: $41.00 USD
https://www.bandainamco-am.com/Ecommerce/product/vg75-03824-00/pot1k-60-degpkg-of-1
Can I get you to fill out the form on the 1st pageSorry for double post, I'm new here.
2x Booster boards and 2x bananas 2 hole version please and thank you!
Makes sense. An additional cable wouldn't be too bad. Besides a Jamma extension, any suggestions on the easiest way to power it separately? Just get a wall to 5V barrel jack adapter, splice it, and solder directly to the board/a fingerboard adapter?You need to power the I/O @tDRG
+5v will suffice. You can power it separately of course.
You can solder the 5v to cn6 next to the analog connector. Pin 1/2 is 5vdc. Pin 5/6 is ground. Pin 3/4 is 12vdc you won't need if you are just using the io for analog MonkeyballMakes sense. An additional cable wouldn't be too bad. Besides a Jamma extension, any suggestions on the easiest way to power it separately? Just get a wall to 5V barrel jack adapter, splice it, and solder directly to the board/a fingerboard adapter?