Recent content by everten

After a lot of modification to @twistedsymphony 's case design, I think I've almost got this. Let me know what you think! Still dongle or adhesive mount friendly.

I'll give it go.

size reference:

I actually made a snap enclosure case, but it's a little fragile at this size. The PCB is pretty small, just under 1.25" square (or 31mm square), hard to tell in photos. I explored the slide top, just don't think it will work well.

That's the idea. There's no difference between versions, it's just whether your use the adhesive pad or not. My only concern is having the 3D printed top plate or not. If you have the top plate to make it look more like a case enclosure, you lose access to the screws since they will be on the...

Here is the top plate idea, not sure what's better. Also including photo of dongle method with shorter harness. Let me know what you like!

Yes, @twistedsymphony is correct. There are 3 holes so this can be mounted however you please. The adhesive pad (1" square 3M VHB) works quite well. I'm printing a top plate to make this look more like a case. I'll upload some photos tonight. This also works good as a dongle if you don't want...

The Atomiswave mod is nearly ready. This one is a bit different than previous boards since there is no clear mounting point. The current solution is a 3D printed plate that can be attached to the Atomiswave case with provided adhesive pad. It can also just be used as an in-line dongle if you'd...

Sorry I missed this. Unfortunately, no plans for the that MVS model at the moment as it is not requested often.

Thanks! Really just 4, but maybe a few extra for the inevitable bad crimp.

Does anyone have some extra RA-SC1290 pins they can sell me? I can only find them in huge quantities.

Thanks. I’ll pull it out to look.

What is pinout for Auxiliary 1 and 2 on the IO board? I couldn't find it documented.

Thanks, what about the black G connector end?

My G connector is missing wires for buttons 7 and 8, guessing this is normal. Are most people pinning them or wiring direct to Brooks or Arthrimus IO? I'd prefer to pin them if someone can point me to the part numbers. I ordered these 2P x 8 button harnesses that have separate connectors for...