Recent content by kazuyajin1080

VGA connection will give the best picture for the system Y2. I dont have a cabinet, but I do use a supergun and connect the VGA with the dipswitch set to VGA mode. then use the jamma edge as a means of powering it on, but you can also use a sun power supply like that of the naomi in order to...

ah woops. no worries :) good luck with the sale~

is the sunset riders still available?

Finally was able to obtain the namco system 1 stereo ! I am excited man~

This is probably a silly question, but lets say I was wanting a kick harness adapter made for street fighter the movie PCB would you be able to make one? If so, how much?

Right now I have the HAS as the main supergun, then use the jammer extender connect the HAS to my cps2, both the CPS2 and the HAS have their proper kick harnesses attached. Yet, when I play I get buttons 1-5, but 6 when I go to the test menu it shows that it is just pressed when it is not. Do...

I have recenlty got installed a CPS2 header on my jamma extension, however, I am still not getting access to button 6...I thought this would remove having to cut any trace. Can anyone give a recommendation?

refer to this thread. https://www.arcade-projects.com/threads/namco-system-1-roll-up-pack-all-roms-for-the-system-1-kit.17560/

I would like to be added to the list and with plexi glass as well.

I have a feeling I need to really replace my battery in the atomiswave in order for this to be saved onto the cart/system itself.

Thank you RTW and darksoft for being able to support me on this. It was my first time being able to flash these kind of modules and setting up a multi without support from one of my friends I usually have help me out. Feelsgoodman~

Sorry this is a dumb question, but would I be able to do that with the same programmer? I used the Xport flash cat. Edit: I think I found it, and now will be doing the comparisons. Edit part 2: After reseating for the nth time and made sure the modules were flashed correctly. I also made...

when I put the original eeproms, keycus, the board works fine....so would this be an issue that maybe I programmed the modules incorrectly...even though I believe I did them correctly. Should I reprogram them? If it is the module situation...how would I go about erasing and re-writing the...

I made sure that the modules were programmed properly, but I also did a test by putting the original game back inside. I will try reseating the board.

I followed a tutorial on youtube and removed the ones necessary, minus pal and something else the person mentioned. Also I should mention that the game I used was tank force, and I also made the sure jumper was according.