Recent content by LWK

Any advice on these pictures? Anyone see anything that is a red flag? I am new to JVS. Jamma guy here. This is my only JVS cab and I sort of want to keep it stock. I have other Jamma cabs.

I did a restoration on it, I'll check that I/O Board. I just need to remove the screws. I only have one JVS board KOF 2002um. I'll recap the chassis at some point also.

I am running a KOF 2002 UM. JVS is connected, USB connector, etc. I get nothing from my controls. Anyone have a similar issue? Any idea what the issue might be? I'm getting ready to pull up the side rail and make sure the wiring is good there also..

YO! Good luck with it. It's a fun project.

Had a good day today and a entire section cracked out of my Rockman 2. I now need a new top half. Please PM me if you can help. Hell, one with a Rockman 2 sticker intact with be awesome, but I won't hold my breath on that.

Any help appreciated. I am restoring a vega 9000 DX and wanna put two new ones in. One of the posts broke off the other pot at some point in its life span. I'd prefer the posts to not be plastic, but whatever works. I want the pot to have the two grounded side pins.

Megalo 410's are interesting because I'd assume quite a few were inherited. That is the story with mine.

I love this machine so much. I need to source the bottom back part. I just made the inside jamma as it was gutted when I got mine.

No, projecting on a mirror.

Film installed. The glass is tinted, and the film was black. Had to bump the brightness. I'll be honest. I sort of wanna swap out my benq for a better condition one anyways, but I could always go grey, but ugh, it's just a endless pit of work. Might be time to settle for the time being.

Update: I ordered the film that you attach to the glass via water. I ordered black. Tiff_Lee had done a test with the samples on the previous page. I also wanna see how this goes. After this is done and I get a better power supply for this cab. My project is essentially done. At that point, it's...

It's been some time, and I am nearing the end of this project. I even have and original marquee now. Got some jumpy screen issues with the gonbes. Any other RGB>VGA converters out there? I also want to drop the rear projection material and go with the black adhesive. I literally just tape it to...

Extra thanks Kujako. I installed the caps tonight, I'm 100% again.

I need like two. This was a EXCELLENT help, thank you so much.

Okay, so the rating is 223. I read some things and saw a video. I think this is what I need, but it has been discontinued: https://www.mouser.com/ProductDetail/Murata-Electronics/DSN9NC51H223Q55B?qs=LSvAQ5kvDJE3KYc3%2BMOy5Q==