I had this same problem. The solution for me was the IDE cable that I had went bad. I replaced it and it still didn't work. Then, I got the bright idea to flip the IDE connector that connects to the motherboard around (notched side facing up). It worked like charm after that. I hope this helps.
The game I’m running is soul Calibur 2 or 3. My voltage is off the jamma edge is 5.1 on my super gun and 5.0 in my cab. There isn’t any sound on boot up. Ive let it run for about 2-3mins. The weird thing is I can’t even eject the dvd tray unless I remove the ide cable and then the light will...
Hey @undamned I have two of your screw terminal decoders. One works fine and the other has a stuck Input always on @ the P1 slot. This occurred issue occurred after I updated it. I have attempted to troubleshoot the issue. What I have found is that no matter which wire I plug into P1 it will...
Has anyone encountered this before? The DVD drive does not power on whenever the IDE cable is plugged in. Whenever I remove the IDE cable from the DVD drive the DVD drive will power on. There is only a black display coming from the 246 rev B. I have attempted to remedy the situation to no...
I pulled this board out of storage (stored in a cool dry anti-static bag in a card board box) and when I powered it up I was greeted by graphical errors. The error seems to be on character sprites. When in test mode every thing passes. I am unsure as to where to begin to solve this issue.
Here...
I think it may be an issue with the undammed controller converter. I had a similar issue with my setup. However my super gun is an old super nova not a HAS. When I updated the firmware on my UD converter one inputs was continuously on. It was remmedied by updating to a newer firmware.
UD-USB...