Pm sent.
I've got the "net" part of the net dimm which I bought for a dimm I had. Turned out to be 1.xx.
Could I assemble that net piece with this dimm to make a net dim to use with pi force tools?
I like your candy cabs.
I've got a Vewlix FC 1p in good condition with 1080p lg screen, House of the dead II dx w/lcd in ok condition that I need to put back together and a Warzaid 2p with a nonworking 2p gun.
Does any of that interest you?
That plug is the volume control and goes to the potentiometer. Two of the pins are shorted like in your picture. 2+3 maybe.
The others are left, middle and right and go to the pot. I can check on one I have and confirm.
Here is a page where someone is troubleshooting the sound and has some...
I printed two of these and they turned out great. Thanks for the share. I'll have to get some pictures and share them.
Did you design a 3d printed solution for the panel as well?
Can you share where you got the files if not?
I posted in a few groups / forums about a 29" Kortek 2901M with a wiggly yoke assembly as it had the adhesive cracked.
This turned out to not be an issue as everyone stated. A little hi-temp silicone and its solid.
The Monitor itself was not powering on at all and I got working again after I...
I picked up an arcade game with a Kortek KT-2901M CRT. I removed the chassis to replace caps but saw that the Yoke assembly adhesive is cracked. What is the best way to re-adhere it so it does not move? It would need to be something high temp I imagine.