Recent content by tiff_lee

That was my first impression as well, this is the second (maybe third) feedback i've seen this year for deals that didn't happen and stopped at the messaging phase. With regards to formal guidelines the pinned post does say Perhaps this needs revision but the way I read that is it's implied a...

Yeah looks great but i'm dubious about what availability is going to be like, at that price point I can see it being bought in bulk and marked up

I have this metal bracket/mount and I can't remember what it's off, came with a bulk load from yahoo Japan a long time ago, it may have come with a bulk lot of Namco 246/256 units so may or may not be related to them... look familiar to anyone? Cheers, Lee

Hi all, I needed half a dozen GBS Control units for various cabs and decided to have a go at making the PCB mount i'd seen online, could probably do with some changes but here it is as V1. All you need is the PCB itself, a PLCC 44 socket with the internal standoffs trimmed off and some short...

GBS Control will improve the functionality View: https://www.youtube.com/watch?v=fmfR0XI5czI https://github.com/ramapcsx2/gbs-control https://ramapcsx2.github.io/gbs-control/Wiki/

I was wondering if the problem was being caused by the use of this: Mitsurugi_w_NoCD Utility.iso , assuming it is this https://www.arcade-projects.com/threads/mitsurugi-ws-cpsiii-nocd-utility-disk.16/ but from reading the thread that is to write an encrypted No CD image to simms using a...

I might be missing something here, but OP has:- Ultrabios NoCD cart (unless I am misinterpreting this "Darksoft repro CPS3 cart with UltraBIOS + NoCD") is missing a 128mb simm Surely this needs to be a CD bios to install the game and you need that additional simm.

Thanks, not bad for the first attempt at making a PCB on kicad. Yeah I should sell them really not like I need a pile of them, I need to order more switches first and I was going to 3D print some spacers for each side the same height of standard PCB feet

and done, created a panel of two together so I could get the 45 deg chamfer on the fingers, a single board was too small to meet the jlpcb pre-requisite. The side pieces and boards easily snap off (v-cut).

@shelcoof for future reference if you're using paypal and its a foreign currency transaction consider signing up to Wise. Transfer money into your wise account (from your actual account not credit card as that may classify as a cash advance) then pay via paypal in the sellers currency. On your...

That ARRX15G looks pretty flash for an old remote, I have a oneforall JP1 remote and yeah it's a bit of a pita, i've done it through this website before https://www.simpleset.com/ you follow the prompts and it generates the file you download into your remote using the USB connection...

Good luck in your search as i'm sure you've discovered these are terribly brittle these days i've had some crack merely opening the case. I know you haven't asked this but you may not be aware but have you looked at alternatives, perspex cases , jasens CPS2 case etc

It would appear so

That thread seems to be the opposite of your problem, working RCA out but no jamma out due to a blown amp IC. If you have full volume control through the pot (over jamma) you need to be looking at the signal path after that pot where it splits, see the schematic above the RCA signal path has...

Just to add and for clarification a high to low level converter like that would normally be used for a device that doesn't have a native low level output (like a car stereo with no pre-outs for your amp). So you take an already amplified signal (the speaker outputs) and attenuate it down a...