I used TL866ii plus (https://ko.aliexpress.com/item/4000938528997.html?spm=a2g0s.9042311.0.0.27424c4dQxqOQU)
My old programmer showed OK messages when burning of verifying the roms, but I think it didn't seem to be burnt properly at all.
Yeah, I got happy ending :D
I bought new eprom programmer and erase & burnt roms once more.
The game works when I replaced just two roms, IC8(15786c) and IC17(15787c).
(You can use 27C1024 or 27C210A, any of them)
I think you'd be better make sure that the programmer works properly or the roms...
Hello.
I just finished the test with DDP2 patch by @kuze.
And cut to the chase, it works great!
This is my PGM board & DDP2 cart.
It was Japan region and v102.
There were some troubles with eprom programmer, but I managed to patch the file and burn it to 27C160 EPROM.
LET'S...
I tried again with 10F1, 12F1 and failed :(
and the game doesn't work also when the battery is attached and two roms are replaced.
Maybe I have to replace 27c020 roms(EPR-15780, 15781, 15785)
or use 27c210a rom instead of 27c1024
I didn't know that =O
I just swapped IC8 and IC17 and it didn't work again.
There were no specific error message burning roms but maybe there were some problems while burning as you said.
I have some other rom models (10F1, 12F1) so I'll try them
Hello.
I tried to remove the suicide battery of Segasonic the Hedgehog board today but I failed.
http://members.iinet.net.au/~lantra9jp1_nbn/gurudumps/s32convert.html
I found this page and it says I have to remove FD1149 first, program the appropriate file to two EPROMs, and replace them...
// ic3b4ll
I successfully connected with the help of an expert, and he advised me of the shorting issue as you said.
Thank you!
// DrBackhands
I finally succeeded in connecting them with the help of experts and panel manual.
(Sorry, my panel was Aerocity, not Astrocity)
Eight wires (per...
//DrBackhands
Thanks to very detailed reply!
I have PCB with I/O board and Official Sega Astrocity trackball panel(I've heard that it is for segasonic only)
But the trackball panel has only 8 wires per person and someone says I need to attach molex 26p connector to I/O board and just connect...
I also think so, but trackball panel has only 8 wires per person (I think they're two 5V, two GND, XA, XB, YA, YB) so it doesn't seem to need 11p or 10p and I'm still a little confused..
It's really far from your posting but I found this while trying to solve the trackball issue and leave a reply.
Did you find out the solution?
I also bought SegaSonic PCB and Sega Astrocity trackball panel but I don't know which components is essential to connect them just like you...
The manual...