Search results

Updated kits tried with three different failures. Waiting on mitsubishi CP710 to arrive as it looks like I'll have better luck procuring for that printer.

I think this machine may have an undumped version of the Print Club "California Ver". Looking at dumped roms I haven't seen this one on any sites or able to see any mentions on searches. The front of my machine has a damaged sticker with some of the frames in view and I attached the image of the...

(Cross posting my post from KLOV- mainly because I see a lot more posts about print club stuff over here!) Backstory: Was out at CORGS-CON in Columbus last weekend, me and friends had brought out a 16 foot truck full of games for people to play (various consoles, a full 10 station Steel...

Know theres a decent chance it's gone by now, but if you have any print club stock left I'd definitely be interested! Hope sales went/ go well otherwise! =]

Yeah, once construction is done in my basement (currently getting a french drain put in) I'll be putting my machines back in place and tweaked up again. For tonight, back in plastic wrap the machine goes! Cheers again everybody!

After getting a new cable from highscoresaves and mounting everything back down I am well up and running! Cheers again to the lot of you to help the troubleshooting process, you all rock!

Success! One corner was a little loose that I didn't get when pushing down the sides. At least it is working with the decrypted files now! Now to just figure out the encrypted files. Hopefully it's just the key cable now. Again, very grateful for the lot of you!

PROGRESS! Did another round of disconnecting A/B board, discharging EXC5, and reloading the larger 32gb sd with the decrypted 2020 roll up pack I got off of archive.org . Much better results than I have been! Going to try the 2GB I have next with a couple of the games and see...

It was from highscoresaves- added to the same purchase when I bought the 2020 darksoft kit The wires look a little criss-crossed but it does look like pin 2 is connected to 2, 3 connected to 3, 4 connected to 4, and 5 to 5. Looking at that other reference image, should the pins be going...

Powered off and unplugged board, separated A and B board, shorted EXC5 on bottom of B board (middle to right, middle to left, and across all three) for 60 seconds a piece Same result. Thanks for the assistance, appreciate you all!

Here's an album of the Samsung 2GB test- same results Screenshots of results and the SD cards: https://imgur.com/a/WuzzWSZ Also posted two photos of power on- it is brighter black before the flash and then goes darker black after the "All done: Have fun!"

I have a lot of 32/64 gb ones, but their mostly higher speed ones from my wife's cameras. I found an older 2GB Samsung microSD I'm formatting and writing part of the rollup pack to test now.

Here you go! Sorry tried the best I could there to keep it straight XD. https://imgur.com/a/VbNNT5K

Here's some photos of the key writing cable I got from highscoresaves, Installed: https://imgur.com/a/vSTgwS5 Cable itself: https://imgur.com/a/PcGIyho I did not, good suggestion! Tried without it and same result unfortunately =[

I started with the bridge pcb, It felt pretty firm, centered, and pressed in (when I installed initially I used the instructions on pushing up from the main board side to secure the bridge in). I did a full reseat and with the bridge it is as far as I can push it down, using the method of...

Running into a black screen when trying to setup my 93646B-7 B board. Know the board was working prior. Tried the Definitive Guide black screen steps firsts -Reseated Key wire -Checked connections of two boards and the bridge -Shorted EXC5 -Tried a decrypted rom sets and the 01010101 / 10101010...