ShllShockArcade
Enthusiast
Hey guys looks like the BOM for Franks minigun is broken for the digital voltmeters on Digi-Key = all showing obsolete now. Anybody know of a replacement that fits the dimensions for the 3D print?
- Thread starter ShllShockArcade
- Start date
https://www.digikey.com/en/products/detail/seeed-technology-co-ltd/114990164/5487639
this red one should work.
this red one should work.
ShllShockArcade
Enthusiast
Was looking for blue or green but that will do. Thank you very much Todo, much appreciated
skate323k137
Enlightened
Get an assortmentWas looking for blue or green but that will do. Thank you very much Todo, much appreciated
5pcs Two-Wire 0.28"LED Digital Display Voltage Tester DC Meter Voltmeter DC2.5V～30V with Reverse Connection Protection red White Yellow Green Blue https://a.co/d/3dSyDRg
ShllShockArcade
Enthusiast
Oh sweet!!!! Thank you!!Get an assortment
5pcs Two-Wire 0.28"LED Digital Display Voltage Tester DC Meter Voltmeter DC2.5V～30V with Reverse Connection Protection red White Yellow Green Blue https://a.co/d/3dSyDRg
skate323k137
Enlightened
No worries, I use them on a lot of projectsOh sweet!!!! Thank you!!
Just be sure to calibrate them to a real voltmeter after installation, i.e. measure the points it's hooked to with a nice meter, and use the Potentiometer on the back of the module to adjust it to match.
ShllShockArcade
Enthusiast
Will do, thanks Skate
