tiff_lee
Grand Master
Hi all,
I needed half a dozen GBS Control units for various cabs and decided to have a go at making the PCB mount i'd seen online, could probably do with some changes but here it is as V1.
All you need is the PCB itself, a PLCC 44 socket with the internal standoffs trimmed off and some short length (7.5mm) pin header (unless you want the D1 sitting high up).
The only issue I found was the D1 with the USB C port on the underside fouls the PCB (just) , I designed this ages ago when the micro was the most common D1. I forget to specify on the file where to have JLPCB to put the serial number although not really sure if critical for such a none thing, also the hole above the socket doesn't really serve any purpose could be removed but meh its V1.
Cheers
I needed half a dozen GBS Control units for various cabs and decided to have a go at making the PCB mount i'd seen online, could probably do with some changes but here it is as V1.
All you need is the PCB itself, a PLCC 44 socket with the internal standoffs trimmed off and some short length (7.5mm) pin header (unless you want the D1 sitting high up).
The only issue I found was the D1 with the USB C port on the underside fouls the PCB (just) , I designed this ages ago when the micro was the most common D1. I forget to specify on the file where to have JLPCB to put the serial number although not really sure if critical for such a none thing, also the hole above the socket doesn't really serve any purpose could be removed but meh its V1.
Cheers
Attachments
-
IMG20240429191951-3000.jpg182 KB · Views: 23
-
IMG20240429191957-3000.jpg138.4 KB · Views: 19
-
IMG20240429192025-3000.jpg132 KB · Views: 18
-
IMG20240429192108-3000.jpg110.8 KB · Views: 17
-
IMG20240429192204-3000.jpg168.1 KB · Views: 16
-
IMG20240429192206-3000.jpg162.3 KB · Views: 16
-
GBScontrol.zip56.3 KB · Views: 15