hoagtech wrote:
Should I drive up the voltage a bit or are those good readings?
On the hunt for: Dinoking, Mushiking, Love & Berry, Egret 29, Grand Am Q25, Capcom New Concept 2, and Naomi guncabs.
This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.
hoagtech wrote:
Should I drive up the voltage a bit or are those good readings?
hoagtech wrote:
I hooked up the Kun and got the these voltage reading
+5.08
-5.02
12.02
Should I drive up the voltage a bit or are those good readings?
The post was edited 1 time, last by Hatsune Mike ().
The post was edited 1 time, last by Hatsune Mike ().
New
Hatsune Mike wrote:
If your plan is to scrub around the inside by hand while it's assembled, pushing around wires, etc. I strongly recommend re thinking it and just taking everything out of the cab. What are you getting out of this testing? You have already established that the monitor, power supply, and basic harness are functional, albeit with some maintenance needed.
New
New
DecepticonZero wrote:
Just a heads up, that control panel surround is an aftermarket one. If you buy reproduction Aero art, it's not going to fit it.
New
The post was edited 2 times, last by DecepticonZero ().
New
DecepticonZero wrote:
Aero City control panels are not centered on the panel surround. The one pictured above is centered.
Went back and looked at your pictures. Your other three cabinets have real surrounds. They're all off center.
*Edit* The sticker on the third party surround was supplied with it from a company called river service. You could get the surround powder coated or brushed stainless. They actually still sell the panels, but they're trash.
New
New
New
1 Guest