What's new

danzk

Beginner
Joined
Feb 16, 2020
Messages
12
Reaction score
6
Location
Melboure, Australia
I recently bought a Sencore CR7000 off ebay and it isn't working quite right.
None of the RGB knobs work when adjusting the cutoff and lo tracking.
I've tried different adapters and even when I test a working tube it says that it's dead.

Can someone with a working CR7000 please do me favour?
Connect the leads of the universal adapter G1 and G2 together with the G1 short function selected and post a pic.
The last page of manual says that all 3 guns should read a short when this test is performed however my unit doesn't.
I'd like to confirm if what I'm getting is normal or not. I believe that there is something wrong with the G2 on my unit.
84453616_170852401002327_1612047495595032576_n (2).jpg
 
Here is my result.
 

Attachments

  • 20200218_234122-1612x1209.jpg
    20200218_234122-1612x1209.jpg
    385.9 KB · Views: 234
Thanks a lot, it that definitely confirms that there's something wrong with my unit.
Not really sure what i'm going to do about it, seems like Sencore don't really want to repair these units anymore.
 
Requested. I'll definitely give it a shot.
 
you should have access now. If not send me a pm
 
I followed the field test guide and here's what I got.
Filament volts – ok
Bias Voltages – Nothing
Cutoff – Nothing
Reactivate – Nothing
Restore - Nothing
 
Back
Top