Vewlix Vs questions/advice taito x2

[Usukane]

So just picked up a Vewlix vs (first time having a vewlix) I know the IO thing has been talked about a lot.

was hoping this was gonna be plug and play.. never that easy lol


trying to figure out my options for operating a single taito x 2 multi in there. KC sent me this jvs to jamma I/O I’m assuming I’ll have to rewire controls/service/test/coin with a jamma harness.. which I can do.. question is How do I power this board. Do these type draw power from the jamma harness or a jst connector? USB??


was missing the control panel I/O

I didn’t see anything in the forums with this particular I/O (I tried)

Am I over thinking it is their an easier way?


Thanks for any direction.. I have a taito x2 working in a NNC if there is something easier to do for just the cp that would be ideal.. I think I may prefer a typical sega or taito I/O with a 60 pin connector idk..

 

[Derick2k]

I say have KC get you the correct Taito JVS IO if possible.

or get a Arthrimus vewlix sega io adapter and a sega type 3 jvs io, can be found for $10-20 on yaj.

https://arthrimus.com/product/vewlix-sega-i-o-adapter-kit/


the last pic show the JVS vs board to link up 2 cabs, I doubt you will end up using it.

 

[Usukane]

I can use for splitting video at least lol I'll keep buggin kc he said he may have this I/O hope so...

 

[Derick2k]

I can use for splitting video at least lol I'll keep buggin kc he said he may have this I/O hope so...

nope either, use for X4s with some some specific games. USB Io, required a customs harness also.

need one of these for jvs games

 

[Usukane]

Say I could use the ones he sent? How do I power the jamma one I have a jamma harness laying around I could use. Does it pull from the jamma edge or one of the jst connectors. If not I’ll start Hunting for some sega I/Os

 

[Usukane]

Also I don’t think this versus has that 60 pin connector so I don’t think I would need the adaptor? Would just need a 60 pin for controls from the sega I/O I’ll double check tomorrow

 

[Derick2k]

The pinout on the 60pin connector is different between sega & taito, this why you need the adapter if you want to use a sega io in the vewlix.

The jamma edge IO he sent you is meant to adapt JVS games to Jamma cabs.

 

[Usukane]

They do have have “G” connectors 2 of them 1 for each side I guess I could get that and wire a harness from 1 player panel to the 2 player side. Or do a custom harness straight from the sega type 3 to the “K” Connectors. Ordered the I/O gonna keep working on it

 

[Usukane]

ordered type 3 from Yaton but idk when it’s gonna show cause of all the shit going on. Also the sega converter gonna build a k > j wiring harness and pull it through to the p2 side Thanks for your input @Derick2k