Hi,
I did a remote for the H-Size coil. The coil was connected by all their four feets, so I just did the same on a small pcb where I deported it. I didn't reproduced the bridges between A & B and C & D.
What's your advise on this, should I add the two bridges?
Btw, if I test it as is, any big trouble, heat, serious damages or unreversible issues? Thanks!!
I did a remote for the H-Size coil. The coil was connected by all their four feets, so I just did the same on a small pcb where I deported it. I didn't reproduced the bridges between A & B and C & D.
What's your advise on this, should I add the two bridges?
Btw, if I test it as is, any big trouble, heat, serious damages or unreversible issues? Thanks!!
Last edited: