Hi Here is the news Sorry for my english not very correct :/ I tried another VGA cable, it's the same problem .
I decided to redo a large part of the Neckboard & Toshiba PD1843 for the welds.Clean up any excess Flux originally.
I'm also going to change the RGB amp. I would do a Capkit at the same time.I
unsoldered this little PCB I do not know what it is for ?
I'm also on an Arcade Repair Group on Facebook.I talked about my configuration problem in memory of my settings.Because the PD1843 board no longer keeps the settings in memory with the original remote control .Only the Extended Menu Remote keeps these settings.I put a photo of an NEC chip that I did not know One of the members said that the chip was the AVR microcontrollers custom chip .Toshiba D29C051 Monitor manual/circuit diagram