What's new
By:
Filters

Blast city power supply recapped but now it's not turning on?

Lmfao!
Gd kill switch! Haha
I wasn't strong enough to get it super tight

Used a pair of pliers and jammed it into the kill switch button and tada! It works.

❤️

Thank you all!
I feel so dumb... Lol
 
With a blast city, we’ve all been there. Glad it’s working!

Now make sure you adjust your voltage under load to 5.0v on the jamma edge. A little high is ok like 5.05v but not too high or low. Each pcb uses a different amount of power so check each time.
 
Can do! :)
I'll make sure I tweak that now so I don't get antsy and put a PCB in there to try lol
 
You *need* to have a pcb in there, you are adjusting the voltage for each different pcb. Every time you change boards you need to adjust voltage to 5v for that particular board’s load.
 
Really helpful thread.

I just got a Blast City (I'll create a showcase thread this weekend) and I'm going through this exact thing.

I just recapped the audio and PSU boards. I'm waiting on a key to get into the control panel and a kill switch bypass plug. Hopefully it turns on after all that.
 
You must log in or register to reply here.
Back
Top