Hi!
I just got a new monitor today
It shows Wgm 2792 U0TS09B
On the chassis, from my reading, it is a
Wells D2900
(Correct me if am wrong)
http://www.wellsgardner.com/wp-content/uploads/2016/08/D9200_27_33.pdf
In this spec sheet, it says an isolation transformer is not required but, I am all about making sure Idiot proof things lol!
Question:
1) if I touch the board while it's powered on, with no iso, I can kill the PCB right? Or is there one built in?
2) Could I add an isolation transformer? If so, would any old one work?
The monitor spec sheet says
Input 90-260 VAC so I assume a 120v iso would be just fine.
Is it wise to do this or is it over kill?
Just curious as I am prone to breaking stuff lol
I just got a new monitor today
It shows Wgm 2792 U0TS09B
On the chassis, from my reading, it is a
Wells D2900
(Correct me if am wrong)
http://www.wellsgardner.com/wp-content/uploads/2016/08/D9200_27_33.pdf
In this spec sheet, it says an isolation transformer is not required but, I am all about making sure Idiot proof things lol!
Question:
1) if I touch the board while it's powered on, with no iso, I can kill the PCB right? Or is there one built in?
2) Could I add an isolation transformer? If so, would any old one work?
The monitor spec sheet says
Input 90-260 VAC so I assume a 120v iso would be just fine.
Is it wise to do this or is it over kill?
Just curious as I am prone to breaking stuff lol