Hi all!
Hope everyone is doing well during this pandemic.
I have a silly question in regards to my monitor.
My monitor can be VGA or CGA which can be done via moving a cable from one spot on the PCB to another spot.
Unfortunately,
I didn't get a CGA connector when I bought this as the side pins are exposed. (Should be able to wire right to it)
1) I read that I need a 10 Pin .156 Molex adapter to wire up the CGA connector to the JAMMA harness, is that right?
https://i.imgur.com/TsRhWxN.jpg
2) Would this be the correct wiring to put the monitor into CGA Mode?
R from Jamma harness goes to R on the pin
G from Jamma harness goes to G on the pin
B from Jamma harness goes to B on the pin
GND from Jamma harness goes to GND on the pin
SYNC from Jamma harness goes to H on the pin? (**I might be wrong, let me know **)
3) Why I ask this today is because, I was trying to keep from having to go back behind the monitor and switch it from VGA to CGA so I was trying to build something that goes as follows:
E.g Neo Geo to Jamma, Jamma to GBS-8200 (CGA/VGA converter) to the monitor.
Prob is, when I connect it up, it is saying "Out of Range"... Lame!
Any ideas?
Hope everyone is doing well during this pandemic.
I have a silly question in regards to my monitor.
My monitor can be VGA or CGA which can be done via moving a cable from one spot on the PCB to another spot.
Unfortunately,
I didn't get a CGA connector when I bought this as the side pins are exposed. (Should be able to wire right to it)
1) I read that I need a 10 Pin .156 Molex adapter to wire up the CGA connector to the JAMMA harness, is that right?
https://i.imgur.com/TsRhWxN.jpg
2) Would this be the correct wiring to put the monitor into CGA Mode?
R from Jamma harness goes to R on the pin
G from Jamma harness goes to G on the pin
B from Jamma harness goes to B on the pin
GND from Jamma harness goes to GND on the pin
SYNC from Jamma harness goes to H on the pin? (**I might be wrong, let me know **)
3) Why I ask this today is because, I was trying to keep from having to go back behind the monitor and switch it from VGA to CGA so I was trying to build something that goes as follows:
E.g Neo Geo to Jamma, Jamma to GBS-8200 (CGA/VGA converter) to the monitor.
Prob is, when I connect it up, it is saying "Out of Range"... Lame!
Any ideas?