Hello,
I've just started using my HAS. it works great on most of my PCBs however some just display a blank screen (the board is running fine, just not displaying picture properly). Sometime the picture displays briefly then disappears.
I'm using the following configuration:
- HAS V4.1
- SCART cable supplied with HAS kit
- Sony PVM 2950Q
- gscart SCART switch (doesn't seem to matter what port I plug it into on the switch)
- HAS set to buffered Csync
- PVM has internal 75 Ohm termination
- I dont use any sort of sync stripping
boards that display this issue include:
- ghosts n gobline
- tumblepop
- cabal
any help appreciated!
I've just started using my HAS. it works great on most of my PCBs however some just display a blank screen (the board is running fine, just not displaying picture properly). Sometime the picture displays briefly then disappears.
I'm using the following configuration:
- HAS V4.1
- SCART cable supplied with HAS kit
- Sony PVM 2950Q
- gscart SCART switch (doesn't seem to matter what port I plug it into on the switch)
- HAS set to buffered Csync
- PVM has internal 75 Ohm termination
- I dont use any sort of sync stripping
boards that display this issue include:
- ghosts n gobline
- tumblepop
- cabal
any help appreciated!