I've been trying to get RC de Go / Go by RC to boot up on my Taito G-NET using information from an old post on a German forum:
https://www.arcadezentrum.com/forum/boa ... oller-mod/
Basically use a 5kOhm pot for steering and one for accelerator, tapping
5V from pin 1 on the 4-pin header on the FC PCB, GND from pin 10 on the
"Analog" header and the divided voltage to pin 2 for steering and pin 3
for accelerator.
Even with the above connected which should allow the game to boot, the
game goes into a reboot loop sometimes ending in a "System Error".
What am I missing?
Are there any specific dips to be set?
https://www.arcadezentrum.com/forum/boa ... oller-mod/
Basically use a 5kOhm pot for steering and one for accelerator, tapping
5V from pin 1 on the 4-pin header on the FC PCB, GND from pin 10 on the
"Analog" header and the divided voltage to pin 2 for steering and pin 3
for accelerator.
Even with the above connected which should allow the game to boot, the
game goes into a reboot loop sometimes ending in a "System Error".
What am I missing?
Are there any specific dips to be set?