Here's my Yellow CPS2 Multi!
That is fucking fire right there. Sick.
Here's my Yellow CPS2 Multi!
That is fucking fire right there. Sick.
Many thanks. That was my intention was to make it look like it just came from the factory. I even have the FBI Warning sticker on the back, and the various other stickers that I could reproduce myself. Etienne over at KLOV is producing foil backed stickers, so I have a request in there to get the Dynamo sticker that goes in the upper right of the kick-plate panel.That cab looks brand new
What are you talking about?! Not special?!Nothing special, but here is my setup:
You're so right!!EVERY Darksoft multi is SPECIAL! Therefore your setup is special.
I really like how everything is self-contained there, and I'm keen to do something similar with my Darksoft setup. One thing I noticed though, is that the ribbon mounting is taller than the up/down/enter buttons. How can I address this to make the LCD unit fit like you did here? Does it involve soldering the ribbon points? Or is there a way to make the existing ribbon fit?My setup, no cab for me :/
I guess if you are going to fix the screen to the case, there is not much point in it still using the original connector. I bet gojira54 removed the connector and soldered the points to it. You still can remove it from the multikit, though.I really like how everything is self-contained there, and I'm keen to do something similar with my Darksoft setup. One thing I noticed though, is that the ribbon mounting is taller than the up/down/enter buttons. How can I address this to make the LCD unit fit like you did here? Does it involve soldering the ribbon points? Or is there a way to make the existing ribbon fit?My setup, no cab for me :/
I'm planning on doing something similar to my CPS 2 Multi setup soon. My plan is to desolder the female ribbon connector off of the front of the LCD and resolder it onto the back. I'll post pics once I get it done.I really like how everything is self-contained there, and I'm keen to do something similar with my Darksoft setup. One thing I noticed though, is that the ribbon mounting is taller than the up/down/enter buttons. How can I address this to make the LCD unit fit like you did here? Does it involve soldering the ribbon points? Or is there a way to make the existing ribbon fit?