Looking to build a decent kick harness for my MK2 PCB.
Now there is some information shattered on the web on what type of connector is used, but no Molex part numbers are mentioned...
The connector type should be:
Molex 15 pin 0.100"
Does anyone have to correct parts number for the housing and the pins so i could order it from a supplier?
Also if someone could confirm the exact same connector type is interchangeable between MK2/3/4?
I thinks MK1 uses a 12 pin instead of 15 pin?
Now there is some information shattered on the web on what type of connector is used, but no Molex part numbers are mentioned...
The connector type should be:
Molex 15 pin 0.100"
Does anyone have to correct parts number for the housing and the pins so i could order it from a supplier?
Also if someone could confirm the exact same connector type is interchangeable between MK2/3/4?
I thinks MK1 uses a 12 pin instead of 15 pin?
