DJLC
Professional
I recently got my CPS2 multikit and, after the full installation, I get nothing but a blue screen. The loader screen board works, it displays the game list and tells me when its loading. At that point the screen goes black till it says its done, then it promptly goes to blue again.
I have a Revision 7 board, I installed the PAL G which I got from the kit, I checked continuity on all jumpers, and I currently have the jumper set on the CN9 connector (its always connected, should I only have it connected when booting and disconnect later?)
I am using a Sandisk 2 GB card but it is formatted correctly (Fat32) so that could be an issue. I'll pick a Samsung Class 4 card up today to make absolute sure, but I'm running out of ideas to check.
Anyone see something similar?
I have a Revision 7 board, I installed the PAL G which I got from the kit, I checked continuity on all jumpers, and I currently have the jumper set on the CN9 connector (its always connected, should I only have it connected when booting and disconnect later?)
I am using a Sandisk 2 GB card but it is formatted correctly (Fat32) so that could be an issue. I'll pick a Samsung Class 4 card up today to make absolute sure, but I'm running out of ideas to check.
Anyone see something similar?
Last edited: