NAMCO FFB Board: SW2

    This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

    • NAMCO FFB Board: SW2

      After some minor testing with Mario Kart GP2, WMMT2 and WMMT3 on a WMMT1 cab, I was able to get all three games to work with the same Namco FFB board I have. I noticed that there are multiple versions of the Namco FFB board. The one I have is labeled as "V315 STR PCB". IC16 has a label with "WMM 1 STR-0A" on it which leads me to assume this PCB was configured to work with WMMT1.

      I have seen other boards labeled with "V275 STR PCB" but not sure if it's an older firmware on these chips or what.

      There is a component "SW2" on the PCB with 4 switches:

      WMMT2:
      1: OFF
      2: OFF
      3: OFF
      4: ON

      WMMT3:
      1: OFF
      2: OFF
      3: OFF
      4: ON

      Mario Kart GP 2:
      1: OFF
      2: OFF
      3: OFF
      4: OFF

      I was only able to test with games I have.

      Edit:
      @winteriscoming and @Dion were able to confirm that SW2 controls the baud rate for the game so this lines up with what I have above in the WMMT/ID Emulator conversation.

      The post was edited 1 time, last by freddiefiasco ().