hello,
I prepared my board to the multiboard and all was fine and worked well.
But now I am facing a problem with one of the displays.
An Issue occurred after 10 hours of operation time. There was a sharp term when the display does only show the half segments and the rest has gone.
Now I can only read the half of the shown signature on it.
Is there any possible way to exchange it to get this issue solved?
Or is there any possibility to get it repaired?
I would really appreciate to get support on that?
please find enclosed some pictures attached for more details.
thanks and regards,
Loki
I prepared my board to the multiboard and all was fine and worked well.
But now I am facing a problem with one of the displays.
An Issue occurred after 10 hours of operation time. There was a sharp term when the display does only show the half segments and the rest has gone.
Now I can only read the half of the shown signature on it.
Is there any possible way to exchange it to get this issue solved?
Or is there any possibility to get it repaired?
I would really appreciate to get support on that?
please find enclosed some pictures attached for more details.
thanks and regards,
Loki