What's new

What is your favorite car to use in Initial D?

  • Toyota AE86 Trueno

    Votes: 3 17.6%
  • Mitsubishi Lancer EVO

    Votes: 3 17.6%
  • Toyota Supra

    Votes: 1 5.9%
  • Mazda Rx-7

    Votes: 3 17.6%
  • Mazda Rx-8

    Votes: 0 0.0%
  • Honda S2000

    Votes: 3 17.6%
  • Other

    Votes: 4 23.5%

  • Total voters
    17
It's unlikely that the multi is the problem. The card reader works on my multi setup.

I'm not sure what else to suggest other than sniffing the serial communication to confirm that the game is sending communication. This could help rule out a hardware issue on the Lindbergh's serial port. If it is sending, then it's possible it's not receiving.
 
no, the DIP switch are good.
isn't the problem...

it is possible that the multi is the problem?

seb
What do your DIPs look like? Can you confirm they match what @winteriscoming is reporting?

This is what mine are set to and they both use the same hardware, I just swap out the PC. Card Reader and other hardware remain unchanged.

Lindbergh Multi (TOP): OFF OFF OFF ON ON ON OFF ON
RingEdge (BOTTOM): OFF OFF OFF OFF OFF ON ON OFF

https://imgur.com/a/6E7DVOZ
 
Thank you,
I knew on Ringedge that the dipswitch had an importance to launch the game but I did not know that on lindbergh with multi it was the same, I will try again and I will tell you.
Seb.
 
Back
Top