ShootTheCore
Legendary
I had similar results with my F3 and OSSC when I tested it last night.Connected the OSSC (AV1) with the regeneration switch ON gave: NO SYNC in the display.
Connected the OSSC (AV1) with the regeneration switch OFF got the display to flash with:
261p, 15.43 KHz, 59.14 Hz
The sync LED stayed RED and there was no signal out.
I tried a few combinations powering F3 before OSSC but to no avail.
NO SYNC if HAS regeneration is ON
If HAS is set to buffered sync:
OSSC display: 261p, 15.44kHz, 59.18 Hz
After pressing Info on the remote, OSSC display: VMod: 256x240 LC: 162 VSM: 2
LED is Red with no output signal
Syncs perfectly with the Framemeister if HAS is set to buffered sync. FM doesn't sync otherwise.