- Thread starter enforce1
- Start date
I had one of those in one of my B boards and I ended up drilling it out.. worked fine and didn't leave any marks.
I have heard that you can yank them out though if you are able to grab onto both sides of the pin with something.
I have heard that you can yank them out though if you are able to grab onto both sides of the pin with something.
Same here. Just work your way around it and use little pressure if you don't want to damage the plastic casing surrounding it.
Just got a cps2 today and I had to do the Capcom bolt removal. Luckily it didn't take me long and wasn't too difficult. Just used a flathead screwdriver and pried it out. It was only for the A board however. Eventually I want to replace the noisy fan so it had to be done lol.
The plastic is so soft and brittle, I've never been able to pry them out w/o making marks, so I just drill them now. It's a pain, but I'd rather not bung up the plastic. Here's my strategy:
https://twitter.com/therealundamned/status/1069360026916020226
-ud
https://twitter.com/therealundamned/status/1069360026916020226
-ud
Wow I never would have thought of that. And I also have a dremel tool that I could have used LOL.
