superboredom
Beginner
Hi All,
I've just gotten a New Net City cabinet and I'm trying to get things up and running. I'm trying to figure out some monitor issues, and I'm pretty new to this, so any and all help is appreciated.
I've noticed that after the cabinet has been sitting the monitor does not like to power on during the first and sometimes second/third power cycle of the cab.
Sometimes I'll just hear clicking coming from the monitor, sometimes just a few, other times repeatedly, like so: https://www.youtube.com/watch?v=xYNaomNWhQg
Any ideas as to what the issue might be? I imagine something has to be re-capped or replaced, I'm hoping that it's not a sign of something too catastrophic.
Usually after 2-4 power cycles the monitor will come on. There are seemingly some convergence issues that I think I can adjust, however I notice some alignment issues, as well the picture in the lower right corner "bending in" as it approaches the bottom.
I've tried to capture this in pics: https://imgur.com/a/jPXWP
It's mostly obvious on the Dreamcast image.
Is this something I can remedy with the default adjustments available for that monitor, and if so, what should I be adjusting? Or is this something in the extended settings I would need to mod the remote board for?
Thanks for looking and any help you can provide!
I've just gotten a New Net City cabinet and I'm trying to get things up and running. I'm trying to figure out some monitor issues, and I'm pretty new to this, so any and all help is appreciated.
I've noticed that after the cabinet has been sitting the monitor does not like to power on during the first and sometimes second/third power cycle of the cab.
Sometimes I'll just hear clicking coming from the monitor, sometimes just a few, other times repeatedly, like so: https://www.youtube.com/watch?v=xYNaomNWhQg
Any ideas as to what the issue might be? I imagine something has to be re-capped or replaced, I'm hoping that it's not a sign of something too catastrophic.
Usually after 2-4 power cycles the monitor will come on. There are seemingly some convergence issues that I think I can adjust, however I notice some alignment issues, as well the picture in the lower right corner "bending in" as it approaches the bottom.
I've tried to capture this in pics: https://imgur.com/a/jPXWP
It's mostly obvious on the Dreamcast image.
Is this something I can remedy with the default adjustments available for that monitor, and if so, what should I be adjusting? Or is this something in the extended settings I would need to mod the remote board for?
Thanks for looking and any help you can provide!