File for use with the Discovery kit for cart update:
Here instructions in PDF in case something is not clear:
The post was edited 5 times, last by aoiddr ().
What is a discovery kit? Where do I buy one? What is the cost difference between buying it and doing this myself and sending the board to you to have the service done?
So how is the Pinout to connect the STM32F4 to the ST-V multi cart?
Same as on CPS2? As this one here is just only a 8 Pin Header vs. 10 Pin Header on CPS2...can you addthis to the first post maybe Jeremy?
The post was edited 1 time, last by aoiddr ().
The discovery kit is a pcb module that connects to your pcb via a usb cable and then connects to your cart via the swd connector and allows you to directly reprogram the ARM with new firmware. The same kit can be used to reprogram your CPS2 kit. The kits are not that expensive. If you send it to me to update it will probably cost about the same with return shipping as buying the kit.What is a discovery kit? Where do I buy one? What is the cost difference between buying it and doing this myself and sending the board to you to have the service done?
You can find the instructions for using the discovery in the opening post of the CPS2 support thread.
The post was edited 4 times, last by aoiddr ().