I have a NAC with a Nanao MS9, just got the cab about a week ago. The monitor came horizontal (and worked normally in this position), but I carefully rotated it to vertical with another person, making sure nothing was damaged. First powerup after rotation the chassis clicked wildly and did nothing else so I powered it off and checked to make sure everything was seated, which it seemed to be. Next powerup there was no clicking and the monitor came on, but it started up overbright (nearly white, washed out), the highest brightness kind of concentrated in a thick white line near the left side of screen (or top if in horizontal). After 10 minutes or so the picture turns out normal and looks very good actually, great sharpness and bright colors, except for some red bleed when something is very bright (which I have mostly tuned out). I figure it just needs a recap and continue to use it like this. Now yesterday after turning it on I hear clicks coming from the chassis for a few seconds but the monitor starts up as it normally does and now every time I power it up the chassis clicks a few times but other than that no change, monitor still works normally after starting very bright. Any ideas what the clicking might be and if I should order any other parts in addition to the caps?