I am interested in buying 2
The future of ST-V rests upon our work and your work
It should also work with the S24 multi by leaving one column of pins sticking out on the right. Then game selection will use only positions from 0 to 7.All of the Apocalypse multi's should have the pins installed on the PCB so it's best to conform to that standard.
The extensions will have the female 8 pin header.
This way you can swap the same extension between C2, M72 and probably System 16 seamlessly.
Just to be sure it's wired properly: when you select, say '3', does it correspond to dip1 = 1, dip2 = 1, dip3 = 0, dip4 = 0?
The post was edited 2 times, last by oneleaf86 ().
Just a little note.
Please rename the previous file removing the spaces in the name.
Other than that it should work fine.
For anyone who is going to do this - remember that you need to pull 5v and GND from the same power supply that is feeding the C2. For my setup - I just tapped into the leads off my supergun.
If you don't do this - you get very weird results...
The post was edited 1 time, last by psykom1 ().