What's new
I want to have Dead or Alive on Model 2B, instead of Model 2A like i have now.
Do you know how to do it?
The security chip it's the same as the Model 2A?
 
Just program the two program roms listed here.
I think the security board is the same...
 
Just program the two program roms listed here.
I think the security board is the same...
so you think i just need to use all the eproms from the model2A including the security chip and just program two roms?
 
you need both the ic 16 files :D
Epr-19379b should be ic 15 and epr-19380b is ic 16
I named it wrong
You dont need the mpr file, its already on your board.
 
The problem with converting a Model 2 / 3 game to another game are not the ROMS or the security board (well if you have ROMS were the need for a security board is patched out ;) ), the biggest problem are the (not documented) jumpers on the ROM boards.
I tried for a few years to convert a cheap Model 2 game to Pilot Kids - the point were I could not advance were always the jumper settings.

Thank god I got an original Pilot Kids PCB a few years ago on Yahoo :) .
 
you need both the ic 16 files :D
Epr-19379b should be ic 15 and epr-19380b is ic 16
I named it wrong
You dont need the mpr file, its already on your board.
could you please tell me which eproms i need to use?
 
@Trol are you dumps unprotected, tested and working? I don't remember where i was with it, i just basically had to wait nearly 2 months because of a fake batch of 27c322 on aliexpress and i had to buy them again... i'm pretty sure i have used those dumps (i no longer have kasumi's glitch, thats why) but again, the game crash after few seconds of the first stage.
I'm i wrong with it?
 
Back
Top