I recently got a few boards and one of them was Tumble pop. Infact it is the very same board which was repaired below:
http://www.jammarcade.net/tumblepop-repair-log/
The image is not stable on the board and I realised if I press the DE56 chip on one corner the image stabilises and is crystal clear.
I am not good at soldering but have access to tools like heat gun etc.
Can anyone please guide me how to fix this issue? Will heating up the area and pressing it down fix this problem?
http://www.jammarcade.net/tumblepop-repair-log/
The image is not stable on the board and I realised if I press the DE56 chip on one corner the image stabilises and is crystal clear.
I am not good at soldering but have access to tools like heat gun etc.
Can anyone please guide me how to fix this issue? Will heating up the area and pressing it down fix this problem?