Help me find a replacement tube for my WG D9200

[fsckewe]

Any help is greatly appreciated.

Recently picked up a Club Kart and the things are not looking good on the tube. Three pins on the tube neck connector have sheared off. Getting them back on doesn't look possible, but I'm going to try with some conductive epoxy...or something. I don't know.

On to the real question....It's an RCA tube connected to a WG D9200. I talked to a guy at a local repair shop, but they no longer work in CRTs, so no tubes laying around. Dude said he could source one for me, but I have a feeling it will be expensive. So what can I replace it with?

It currently has a RCA A68AEG25X07. I can try to find another one of those, but what are my other options?

The WG is a 025A1569-001E P857

The tag on the frame is WGM2792-U0TS29K (zero or oh??)

Thanks for reading.

 

[nem]

I think I have one these. I can meter the yoke, so at least you have something to look for.

 

[XtraSmiley]

I’m on my phone so I can’t see your location, but on KLOV there is a guy giving away a 9200 tube with no chassis. Sounds like your peanutbutter to his jelly.

 

[skate323k137]

Just drive up to MI and I'll make sure you leave with a working one.

 

[randomdoohickey]

It's an A68 tube, so there's a very good chance most any random curved or flat non-Trinitron 27" (29" in rest of world) would work that's been pulled from a $10 Craigslist TV. This will depend on pinout and how the yoke measures, but good chance. If you get desperate, I'll bet money on the 29" LG/Samsung tube from one of the current Wei-ya, aka Makvision, 27"/29" being a drop-in (but it's flat, which may be an issue).

https://wiki.arcadeotaku.com/w/CRT_designation_systems

Some examples of somebody putting random consumer TV tubes in a Nanao MS9 multi-sync chassis:
http://www.albyhus2.se/_eget/monitors/Nanao_MS9_CRT_replacement/CRT_nokia/
https://forum.arcadeotaku.com/viewtopic.php?f=4&t=17428

 

[fsckewe]

-

 

[arcadeWC]

Can someone confirm the D9200 chassis will work with a Makvision 27/29” tube? This would be great as I have extra D9200 chassis and a Makvision tube. Has anyone actually tried it? I don’t want to test it yet as my Makvision is new; but nice to know for spares. Thanks.


It's an A68 tube, so there's a very good chance most any random curved or flat non-Trinitron 27" (29" in rest of world) would work that's been pulled from a $10 Craigslist TV. This will depend on pinout and how the yoke measures, but good chance. If you get desperate, I'll bet money on the 29" LG/Samsung tube from one of the current Wei-ya, aka Makvision, 27"/29" being a drop-in (but it's flat, which may be an issue).

https://wiki.arcadeotaku.com/w/CRT_designation_systems

Some examples of somebody putting random consumer TV tubes in a Nanao MS9 multi-sync chassis:
http://www.albyhus2.se/_eget/monitors/Nanao_MS9_CRT_replacement/CRT_nokia/
https://forum.arcadeotaku.com/viewtopic.php?f=4&t=17428

 

[nem]

Can you find out the specs of the yoke on the Makvision?