ok I got my ms2930 recapped. I got it all perfect and I went to go put it in Tate and it all shifted. So I took monitor back out and tried again. Put it back in cab and same thing I took it out and noticed I must of sat the monitor on the cable that goes to front of get that the cab wiring connects too.
I spliced that but now on the lower left the red line has shifted down and I spent hours but it doesn't move at all with strips. Only the white and blue moves. I'm at work and can't take picture. I went from like 5 strips to a ton.
I was just curious could I have done something turning monitor to Tate.
Also if I let the cab sit off for awhile when I turn it on nothing happens in till chassis heats up and I turn it off and on again I get a picture.
Is there some other pot for dynamic convergence like on some monitors.
I spliced that but now on the lower left the red line has shifted down and I spent hours but it doesn't move at all with strips. Only the white and blue moves. I'm at work and can't take picture. I went from like 5 strips to a ton.
I was just curious could I have done something turning monitor to Tate.
Also if I let the cab sit off for awhile when I turn it on nothing happens in till chassis heats up and I turn it off and on again I get a picture.
Is there some other pot for dynamic convergence like on some monitors.