KalessinDB
Grand Master
So mine's buttoned up and I can't tell you 100% sure what I soldered the ground to, but it was one end of the buttons (I THINK it was the side farther from the jamma edge)... I just pulled out a multimeter and checked continuity from one of the ground pins on the jamma edge.Bumping this up as I'm still looking for an answer on this. Instructions were a bit vague and I haven't seen anything definitive in any install pics I've seen so far. Really looking forward to putting this build behind me and enjoying my multi. Thanks.Finally ready to assemble this case and I have a question about the test button connections. My understanding is the signal wires can be soldered wherever on the button. Where is a proper spot for the ground wire?