MSV-U4 / 25 Restoration

    This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

    • MSV-U4 / 25 Restoration

      Whilst I have done many restorations in the past I have only recently become more active on this forum and I thought this game would make a perfect candidate to document my first restoration here :) Plenty of MVS-U4 fans as shown from my first thread on the topic.

      So, this is what I am starting with:












































      Upon receiving it I didn't have the keys so wasn't able to turn it on but was told it was all working. Now I thought I recalled the seller telling me it had a 4 slot board in it too but unfortunately that was not to be... :/ So I got around to drilling the locks the weekend just past and found that it just had a single slot PCB with Metal Slug 4 in it. (See pics)

      Also, as I am in Australia it had already been converted to run on 240V so as expected there was a step down transformer in there (big circular thing mounted to the bottom back of the cabinet).

      Anyway, since I had the front door off I was able to turn it on and thankfully it all fired up ok. Image seemed to have a minor focus issue, so hopefully that is just a minor adjustment on the chassis I need to make later...

      Due to the state of the control panel I obviously couldn't play but could confirm the buttons worked.

      Anyway see attached pics to give you an idea of the state the cab is in...
      Images
      • IMAG1996 (1).jpg

        413.68 kB, 1,264×1,686, viewed 36 times
      • IMAG1999 (1).jpg

        26.83 kB, 294×220, viewed 42 times
      • IMAG2024.jpg

        665.32 kB, 2,248×1,686, viewed 48 times
      • IMAG2025.jpg

        505.01 kB, 2,117×1,588, viewed 39 times
      • IMAG2026.jpg

        299.91 kB, 2,117×1,588, viewed 45 times
      • IMAG2029.jpg

        645.37 kB, 2,117×1,588, viewed 46 times
    • The restoration:

      I have decided to give this the full treatment. I am going to fully strip it, get it sand blasted back and re-powder coated :)

      In my excitement I have already ordered (and received) a complete set of Seimitsu buttons and sticks, which were what the cab would have had originally. The buttons in there now are Sanwa's and are the wrong colour obviously.

      As much as I would like to get a replacement CPO that is silk screened like the original, cost and difficulty wont permit it unfortunately. I will get a new overlay printed and apply it over my existing CPO. Additionally I will get all the other art colour matched and re-printed to go on post the body work being done.

      I have only done a minor bit of tear down so far and will finish the rest off over the coming weekend hopefully.

      Decided to pull and give the old memory card/headphone jack board a bit of a clean... it needed it!!!!

      Just soaked it in Simple Green then rinsed it off under the tap. Blew off the excess water and left it in the sun to bake for the afternoon. A lot better now :)

      Before and after:
      Images
      • IMAG2032-COLLAGE.jpg

        398.62 kB, 1,191×1,588, viewed 42 times

      The post was edited 2 times, last by Pelly ().