Sega System 16B CN1 connector replacement

    This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

    • If the pin is on a side good chance it's a power pin (either +5V or ground). In this case you don't need to replace it since multiple pins are used for power.
      If it's actually used for a signal then swap it with one of the power pins from the sides.
      Looking for:
      - OutRun boardset even untested or not working
      - Sega Super Scaler hardware (Out Run, Model X, Model Y), even with faulty PCM chip



      01010011 01000101 01000011 01010010 01000101 01010100 00100000 01001101 01000101 01001110 01010101 00100000 01000111 01010101 01011001