ZERO_MILES
Enthusiast
Hey there!
My Golden Axe 2: Revenge of Death Adder was working perfectly, but is no longer playing -- upon booting, it stalls on the first screen and stays that way forever.
The board is super clean (I always keep my boards ultra clean and stored away from sun / humidity) and I see nothing worth of attention when doing a visual inspection.
I've tried the obvious stuff (reseatting chips and sub-boards), to no avail.
Can anyone point me to where I should be looking next? I don't have an oscilloscope, so I'm stuck with the average joe tools -- soldering station, desoldering station, multimeter, etc.
Cheers!
My Golden Axe 2: Revenge of Death Adder was working perfectly, but is no longer playing -- upon booting, it stalls on the first screen and stays that way forever.
The board is super clean (I always keep my boards ultra clean and stored away from sun / humidity) and I see nothing worth of attention when doing a visual inspection.
I've tried the obvious stuff (reseatting chips and sub-boards), to no avail.
Can anyone point me to where I should be looking next? I don't have an oscilloscope, so I'm stuck with the average joe tools -- soldering station, desoldering station, multimeter, etc.
Cheers!
