Anselmo's latest activity
-
Anselmo replied to the thread Help: CPS3 Digital AV Installation troubleshooting.After meticulously troubleshooting my install I decided to try it with out the QSB and I got it working. I dunno what was wrong with the... -
-
Anselmo reacted to themisterfalcon's post in the thread NAC Splitfire: JAMMA streaming solution with
Like.
Hi everyone, as a few of you are already aware (thank you!) pre-orders for the next batch of Splitfires are open. The units are... -
Anselmo replied to the thread Help: CPS3 Digital AV Installation troubleshooting.Yep. I'll go home for lunch and snap some pics. Appreciate the help
-
Anselmo reacted to cruzlink2's post in the thread Help: CPS3 Digital AV Installation troubleshooting with Like.
You didn't mention that part, in that case the short is on the cps2digitalav color connectors. Can you take a picture of the digital av?
-
Anselmo replied to the thread Help: CPS3 Digital AV Installation troubleshooting.I will be checking each for shorts thoroughly. Thank you! Just to be clear, when the ribbon cable is connected, the analog output gets...
-
Anselmo reacted to cruzlink2's post in the thread Help: CPS3 Digital AV Installation troubleshooting with Like.
Yes, the short is at the resistor networks, unplugging the ribbon won't make any difference on the analog output. The short is not at...
-
Anselmo replied to the thread Help: CPS3 Digital AV Installation troubleshooting.Thanks for the replies fellas. I snapped a quick picture of the qsb - I got to thinking. If there's a short right here On the qsb and...
-
-
Anselmo reacted to cruzlink2's post in the thread Help: CPS3 Digital AV Installation troubleshooting with Like.
The fact that the issue is showing in analog and digital means you have shorts on the resistor networks where you grab the color...
-
Anselmo reacted to mathewbeall's post in the thread Help: CPS3 Digital AV Installation troubleshooting with Like.
Interesting. The only thing I can think of is the QSB has some funky shorts.... if you used flux - did you make sure you cleaned the...
-
Anselmo reacted to mathewbeall's post in the thread Help: CPS3 Digital AV Installation troubleshooting with Like.
Is this the JAMMA video out? So its fine if you disconnect the ribbon cable, but when that's plugged in - you get the above color...
-
Anselmo replied to the thread Help: CPS3 Digital AV Installation troubleshooting.The issue is both JAMMA and HDMI. The exact same color issue. If you see the picture it shows an error with the RED color bar. I will...
-
Got a hold of these hard to find mods and since I had successfully installed one on a CPS2 a couple years before, I wanted to have a...
-
-
Selling my Sega New Versus City. Everything works perfect. There are no issues. The cab itself is in very good condition. Both monitors...
-
Anselmo reacted to cruzlink2's post in the thread MS-2930S low brightness low contrast, missing red recap/repair with Like.
-
Hey everyone, I apologize for my behaviour earlier. I was not screwed over as money was never exchanged between us but I am just upset...
