Recent content by Ballz

Great Seller here!

No, It had already suicided and as ekorz mentioned, nothing is really dead these days...

Looking to sell the following items tested working: Hopefully no issue with guidelines in selling the complete CPS2 Multi. CPS2 SOLD - Darksoft CPS2 Multi A+B USA boards - $850 (Small corner crack has been repaired on lower right of B board but barely noticeable) SOLD - Marvel Vs Capcom A+B JP...

Please put me down for 1. Thanks very much.

Looks like it was pinned above LCD troubleshooting / repairs

So I must have popped off the Up Button on the LCD screen somehow, but I can't find it anywhere - the actual lower part is still soldered into the board just fine but any idea what the replacement button is called (or where I might find one)? || Thanks

All patched up and working again. I guess there was too much slack in the cable and as my luck would have it, it landed right over the screw hole on the B board. Live and learn.

Well, found the issue. When I put the shell back together one of the screws went right through the ribbon cable for the LCD. I'll see if I can fix this with some jumper wires. FACK ME

Hey All, So I installed my kit today, including the auto reset wire - everything worked perfect. I played a few games, and then loaded up dimahoo - played for about 30 min or so. Now, I can no longer load any different games. I can move back and forth to any of them, but pressing enter does...

Yeah my rev-3 board doesn't have it sadly. Ok no problem, I will connect it to the com connector pin B21 on CN7. Thanks guys!

Thanks Dark, I should have been more specific, I guess I'm just wondering what pin should i use for the other end (CN7 pin 21/com connector, or CN1 pin 28 - soldered) Picture example I've seen

One question I had around the auto-boot feature From the guide it says In order to have also auto reset feature, you need to solder a cable between the SWD5 “dot” in the CPS2Multi which can be seen below and the pin B28 of CN1 connector in the B Board. But in most of the pics I see people are...

This is really good information, Thank You.

lol well there ya go! I feel incredibly foolish now for missing that, but thank you :^)

Thanks for the suggestions guys. So to summarize, Board will work Pull the daughter board and other roms Find a palG chip Jump pin 9 (lifted) to j17 on the multi pcb. I appreciate the feedback and hope to try this out once available.