Recent content by bravesirchris

We got in an after burner climax deluxe where the seat will not move and on started up I just get "Error ABX03 MOTOR DRIVE ENCODER ERROR". I think it might be an issue with the RS232 to 422 BD 839 - 1256R board but I dont know for sure. Any one got any advice ?

Hi all. I'm looking for a 838-14502-01 [Serial Motor Drive Board] for a Sega and Sonic Allstar Racing. but the same board was also in a few different games. Afterburner Climax Harley Davidson King of Road R-Tuned Street Racing SegaRaceTV Initial D4/5/6/7 Outrun 2 SP SDX

SO I have the mains power lead, so power is going from cab 1 to cab 2. But i don't have any of the loom going from cab1 and 2 going to the control panel in the coin mech box. the machine is on a different site but i will upload a photos when I'm on that site tomorrow.

this is a bit of an odd one, But I've got a in a R-tune ( yellow Lindbergh) but it's missing the loom form car 1 to coin box, and coin box to car 2 wiring loom. I've got the main power loom but no other wiring. Dose anyone have a wiring diagram of the loom? I think the loom will be the same...

So to jump on this thread here, I've got a system 357 for a dead storm prates, which powers on but then out about a minute the system powers down giving a over heating warring, I have just redone all the thermal paste but still the same issue. both fan in the case are working so its not that...

so the The RTC chip (timer clock) was replaced and the games was working well, but now just getting "game lock mode". I'm not getting a ERROR P11, do i need to replace the RTC chip again? or will this passcode work ? 00000000 | 47 4B 39 33 31 00 00 00 20 00 55 41 41 00 98 3F |...

anybody seen this error message before? any advice would be a great help.

got the game back and up and working, it turns out it was the Video card in the end.

I did swap the graphic cards but sadly same issue, but i have just got 2 Dell optiplex 740 of ebay so im going to swap the PC.

so the game uses a USB security dongle which I did have plug in the same usb port when i reinstalled the game. ( but i will do it again tomorrow just to check).

So i need some help with a Raw Thrills terminator salvation, the game will just not load. I've reinstalled the game on to the PC ( dell optiplex 740) game installs without any problem. I have swapped the graphic card, hard drive in the PC. I have also tried swapping the I/0 board in the...

thanks for you help, i will give it a go today and see how i get on

so this how its set up at the moment

So the Chihiro already boots from a CF card (as ive got it playing outrun2 at the moment). And ive just fond the outrun2 SP Rom from a copy I made of a piforce. Can i just burn that rom to the CF card? and if so how would i go about doing that?

hay @IMACOMPUTA yes we do resolve this issue but it wasn't me who fixed the board i will speak to the guy who fixed it and let you know.