Recent content by d7onr8

Now that you have the last piece of the puzzle, we will eagerly wait for the grand unveiling of your finished Q25 project @MyztikJenz!

There is no traditional hinge I can see. The third pic in my last post shows the white metal simply pivoting against the darker metal as a fulcrum. I have a video that shows it but can’t figure out how to post it. Edit: We found the hinge and it seems jermz1 was correct! MyztikJenz will...

30 degree and 130 degree angle.

I can see what I can do when I get home, but I don’t think it’s a special hinge or pivot. Looking at other pictures on the internet and your first pic (also your thread on Engineering Stack), I think it’s the shape of the lower cab part that needs to be altered.

Here’s some pics:

Lost one sound channel on my System 2X6. Replaced the 4 SMD capacitors near the LA sound amp chip (heatsinked). Values are as follows: C16 & C19 - 2.2uF, C17 - 100uF, C18 - 47uF.

Update on my situation: With JP1 set to position A, I used this Sanwa button mod from Jimbob0007 which allows the use of a cherry switch wired as NC to activate button 6.

You check out this thread? https://www.arcade-projects.com/threads/カプコン-q-グランダム-25-capcom-q-25-restoration-rgb-mod-ssfii-cpo-enhancements-insights.19960/

I also am having this exact issue with two different Rev A I/O’s on my AWSD. At first I thought it was bad diodes but they test fine with my multimeter.

Very cool, glad you’re fixed for now!

I’ve done the 18 wheeler to crazy taxi conversion. I followed an old sega-naomi.eu post that said to take pin 23 out and place it in where pin 24 would be. Alternatively, you can dual wire pin 23 to 25 and 24 to 26 to make the shifter work correctly. Even though the 18 wheeler steering has...

It was electrolytic. You can see my thread here.

I had a pincushion problem on a Wei-Ya 3129D. Tested all the transistors, resistors, diodes, and pots but in my case it ended up being a bad capacitor so I wouldn’t rule out bad caps in the pincushion area.

Thanks Xed. I was able to make one using a spare RA analog connector. I will need an extra banana at some point so I will get on the preorder list in the future.

Is there a wait if we just need the wiring harness? In my previous tests, I don’t think I had CN1 hooked up from the analog amp board to the analog connector on the I/O and I wasn’t getting responsive results.