Recent content by darkairplane

Please add me to the list as well. Thank you!

Idk what I did wrong but it works now. I took it apart and put it back together again. I made sure a and b boards were seated properly together and made sure the screws were even torqued down. I plugged it back in and works with no more vertical bars! I never knew Cps2 was so finicky. Kinda...

I have vertical bars now after replacing the battery. I “seated” all the roms by pressing them down lightly before I put it back together again after the battery replacement; did I ruin a rom while doing that?

Ok I changed the vertical position and the dead spot stayed there. I removed the glass and unfortunately it was not just a piece of dust. Any ideas? Just have to live with it?

Perfect! That’s what I was looking for. Thank you.

It’s the monitor. I connected another game to it and it still shows. What are my options? Cap kit? New tube? New chassis?

I never noticed it until today but I have a dead pixel/phosphor on my CRT. Is this the Cps3 or my monitor or some magnetic interference(I moved it to another room)?

Anyone know the correct size to replace leg levelers on a mortal kombat 2 cabinet? I would like to replace with Teflon/ nylon /plastic levelers so I can move the cabinet around easier.

Looks muuuch better now, thank you! Gameplay with samurai shodown has much less visible horizontal lines now. Might need a new tube since I can’t bring the brightness down too much to get that nice dark black otherwise I won’t see anything. Lol.

My samurai shodown has horizontal lines in it, any ideas? My puzzle bobble has one horizontal line also. Both carts cleaned. Moved them to a different slot, issue is still visible.

Looking for an original neo geo big red control panel overlay. Thanks.

How do I clean the cart slot safely?

I reseated the cartridge. So far so good. I’ll report back if it happens again. I think I was playing with Hugo vs Yang when it happened if that would cause anything.

I was playing third strike and it randomly went to black I immediately turned it off and waited about five minutes. I checked all connections and I turned it back on and it has been running fine for the past hour now. Any ideas to what happened?? Reseat the cartridge?Should I replace my power...

Confirmed and works fine. Also the System Wiring Diagram in the manual shows number 4 on the main pcb edge not connected to anything also. Thanks for your help!