I have the 412-in-1 Vertical Jamma Board.
My speakers are the Suzo Happ Audio Pro Full Range Round Speaker 3.3" which are connected directly to the board using the L & 10 speaker wires (no amp).
The problem is my audio is about a second behind the visuals. Is this just a trait of the 412-in-1...
@rewrite, thanks. Appreciate the quick response!
Is there a preferred way to connect the loom connector to the pin? I was just going to open it a little, slide it over then clamp it on the pin.
Hi, can someone suggest how I connect my loom connectors to my Sanwa buttons (shown below)? Do I need an adapter or do I need to connect to both pins or one?
Any advice would be appreciated! :)