I upgraded my Vewlix C with a 2p panel so I no longer have a use for the original 1p panel. Includes all the buttons and the stick that were on it when I purchased it.
Asking $225 shipped OBO.
Im looking to sell off my Taito Type X3 system that I was previously using in my Vewlix. This is the 404 version that originally ran Ultra SF IV, which still boots up from the hard drive that came with it. Its got a Core-i5-2400 processor and 8 gb of ram. The big caveat is that the fast-io PCI-e...
The fans in there are so noisy because of how big they are and the high RPMs they run at. At least this was the case for me, and I only have 1 case fan. Start with some motor controllers and see if the lower speeds still give you adequate cooling. You can always upgrade the fans down the...
Heres an admittedly shitty picture of the setup, so sorry you cant see the wiring better. But roughly what you said is correct. I wired up so that the fan was wired correctly up to the motor controller, then out to a female PWM fan header. I then wired a male fan header to the 12V supply in my...
I just replaced the (super loud) fan in my Vewlix FC with a Noctua NF-F12 and wired in a little DC motor speed controller stuck onto the side of it inside the cab. Aside from the speed controller oddly working in reverse of what it should, the whole setup worked great and I dialed in a fan speed...
Mine arrived last night, packaging was amazing and the parts look pro. Looking forward to doing my install this weekend! Now just need to figure out how to wire the monitor controls into the default control buttons behind the coin mech door.....
Thanks again @FrancoB. You're a legend