Recent content by Ivan87

Hi guys, I present to you two cables that I made for my cabinets, since my cables were in very bad condition and with very yellowed sheathing. These cables are a perfect and improved reproduction of the original Sega cable produced for Astro City Nanao MS8-29 and New Astro City Nanao MS9-29. It...

And for mistercade v1? any solution?

No it’s the same

it is not conductive, but can cause the component to overheat during exercise and damage it

Good morning guys, I show you the repair and restoration of this beautiful MS-2932, found in a Naomi Universal Cabinet. The monitor showed no signs of life, both due to the death of HOT and the diode on the XRAY circuit. I also had to remove and fix the coil which had sprayed resin all over the...

UPDATE: Hi Guys, i will not document all the disassembly and cleaning phases of each astro city, first because the site is full of this information and second because it would be too long. I'd like to show you this little "Upgade" that I decided to do in the first astro city, hope you like it...

with a lot of effort, my friend

UPDATE: After disassembling the NAC I saw that the lower rear was badly damaged: I solved it by creating a new fiberglass piece, which I glued with the same resin. The result was excellent, after painting you will not see anything.

Great job, enjoy your astro!

Hello, then 120v is not a problem for the monitor electronics. But be careful if you decide to use a SEGA amplifier for the stereo, because it takes exactly 100v to work. For the Stereo connection do this: modify the control panel audio wiring and run 4 cables from here, 2 for the right speaker...

UPDATE: I'm sorry for the long time spent without updates, but there were so many things to do and more problems to solve. In my opinion, a healthy CRT makes 90% of a cabinet, that's why the first thing to do is undoubtedly to secure the monitor and electronics. Here are some photos of the...

my doubt is if the power supply is able to supply the right amps. These small amplifiers usually want 2/3 amp, while the power supply should only give 1.5 amp.

You're right, it would take more of these problems, thank you

At the moment they are in our private collection

Thank you!