Recent content by Mrhide

When you buy a project, you dont ask many questions: you take what is given. I realized the screen brackets were missing and had a friend (@Barth0lin0) measure a few things, with the intent on fabricating them. Then i get a msg from the seller, after @SnakeGrunger told him that the brackets...

ah yes! 2 minutes of fun, 20 years of payments :D ! your first?!

Well well … just moving it with the handles i though “what a nice case… i am keeping it” After opening it, surprise surprise! :) i guess it wont go in guitarfreaks to run guitar hero after all! 😝 For info, the model#

All right, so here' the Windy 2 "shell" I picked up yesterday. As you can see, it's missing a lot of things. Do I bring it back to original state or do I simply make it jamma? we'll see but jamma is pretty darn simple to do. What I am missing that is essential is the screen holders: any...

...hope I am not breaking any rules here - but if the person who bought the Windy 2 back door and wiring set isn't going to use all of the wiring, I am really looking for a set BECAUSE I AM MISSING IT ALL. Please reach out to me if you want to sell and get some of your money back out of your...

What shop sells NAC with MS9 in Ontario?

You use it with what? I have had one for probably 3 years and it never left the shipping box. Like i dont know what to do with it cause i think it’s just for consoles.

well shit. never sell a board folks! never sell a darn thing!

Check the cf procedure in this thread shall you want to get rid of the gdrom.

Is it much better than before?

calibrate it in the setup you can invert it in the setup you'll need them for the above ;) ... and yes you can recalibrate/remap it not needed / you can create one if you want yes. you can deactivate the card reader in the setup

No. I turn my nose cause you can’t see a god damn thing! I’ve owned AFM but i can never finish a game on RFM… what a disappointment. I must have tried and played more than 800 pins and the 2 p2k are smack down at the bottom. No wonder Williams closed their pinball division right after that.

Unlikely knowing what you so but if you’re stuck, you can always print my bad one

The fujitsu one … of course Thanks! Will give it a shot ps: Found https://consolemods.org/wiki/Genesis:FRAM_Mod which mentions you can use the readily available FM16W08-SG to replace the harder to find MB8464A-10L... I'll give that a try

*6 years later* 8| I revisited this A board which didn't boot anymore with my recently acquired hot air station, changed both at93 again and... ..but it's not 100% : I still get EEP ROM "No Good" and if I try to save settings in EEPROM, I freeze here with this screen, in effect, I...